Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2013 Ford Transit Connect XLFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| ABS module screws | 2 | - | 18 |
| Air Cleaner (ACL) and PCM bracket | 25 | 18 | - |
| Battery Junction Box (BJB) mounting screw | 5 | - | 44 |
| Ground cable bolt | 9 | - | 80 |
| Hydraulic Control Unit (HCU) bracket-to-frame nuts | 25 | 18 | - |
| HCU-to-bracket bolts | 12 | - | 106 |
| Left front and right rear wheel brake tube fittings | 23 | 18 | - |
| Left rear and right front wheel brake tube fittings | 20 | - | 177 |
| Master cylinder-to-HCU brake tube fittings | 23 | 17 | - |
| Stability control sensor cluster bolts | 9 | - | 80 |
| Wheel speed sensor bolts | 9 | - | 80 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.