Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Traction Control System
The traction control system aids in the prevention of excessive wheel spin which will allow the vehicle to maintain traction during acceleration. This is accomplished by the ABS module and the HCU modulating brake fluid pressure to the affected brake caliper(s) and by the PCM modulating engine torque.
When the traction control system activates, the driver may notice a small deceleration or a reduction in the acceleration of the vehicle. This is the PCM modulating the engine torque and/or the HCU modulating brake fluid pressure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.