Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Anti-Lock Brake System
- Description
- Operation
- Component Locations
- Bleeding Brake System
- Trouble Shooting
- Diagnosis & Testing
- Symptom Tests
- Diagnostic Tests
- Notes
- DTC B1318: Battery Voltage Low
- DTC B1484: Brake Pedal Input Open Circuit
- DTC C1095: Hydraulic Pump/Motor Circuit Failure
- DTC C1145: Right Front Wheel Speed Input Circuit Failure
- DTC C1155: Left Front Wheel Speed Input Circuit Failure
- DTC C1165: Right Rear Wheel Speed Input Circuit Failure
- DTC C1175: Left Rear Wheel Speed Input Circuit Failure
- DTC C1222: Wheel Speed Signal Mismatch
- DTC C1233: Left Front Wheel Speed Sensor Signal Missing/Fault
- DTC C1234: Right Front Wheel Speed Sensor Signal Missing/Fault
- DTC C1235: Right Rear Wheel Speed Sensor Signal Missing/Fault
- DTC C1236: Left Rear Wheel Speed Sensor Signal Missing/Fault
- Removal & Installation
- Adjustments
- Torque Specifications
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
