2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

No Communication With Abs Control Module

  1. Turn ignition off. Disconnect 30-pin ABS control module connector. Turn ignition on. Using DVOM, measure voltage between ABS control module connector terminal No. 8 (Light Blue/Pink wire) and ground. See WIRING DIAGRAMSΒ . If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, replace fuse No. 29 (15-amp) located in instrument panel fuse block, and/or repair Light Blue/Pink wire between ABS control module and instrument panel fuse block.
  2. Turn ignition off. Using DVOM, measure resistance between ABS control module connector terminal No. 15 (Black/White wire) and ground. Also measure resistance between ABS control module connector terminal No. 12 (Black wire) and ground. See WIRING DIAGRAMSΒ . If resistance is less than 5 ohms, replace ABS control module. Repeat self-test. If resistance is greater than 5 ohms, repair Black and/or Black/White wire between ABS control module and ground connection.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.