2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Anchor Plate Bolts 85 (115)
Axle Hub Nut 258 (350)
Brake Caliper Bolt 85 (115)
Brakeline Fittings 14 (19)
Front Brake Flow Bolt 30 (40)
Front Disc Brake Caliper Bleed Screws 9-13 (12-18)
Front Disc Brake Caliper Bolts 23 (31)
HCU Bracket-To-Frame Rail
Nut 13 (18)
Bolt 7-10 (10-14)
HCU-To-Bracket Nut 13 (18)
Hydro-Booster-To-Firewall Nut (4.6L) 15-20 (21-28)
Master Cylinder-To-Booster Nut 19 (25)
Power Brake Booster Nuts 19 (25)
Power Steering Hoses (4.6L) 11-14 (14-20)
Rear Bleeder Screw 15 (20)
Wheel Lug Nut 85-105 (115-142)
INCH Lbs. (N.m)Β 
ABS Control Module-To-HCU Screw (1) 21-30 (2.4-3.4)
Master Cylinder Bleeder Screw 80 (9)
Rear Brake Pin Retainer Bolts 80-106 (9-12)
Wheel Sensor Bolt 62 (7)
(1) Tighten in sequence to specification. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.