2000 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Abs Hydraulic Control Unit

  1. Clean dirt from master cylinder reservoir cap. Remove cap and fill reservoir with clean DOT 3 brake fluid. Connect drain hose to right rear bleeder fitting. Submerge other end of hose in clear container full of clean brake fluid.
  2. Loosen bleed fitting about 3/4 of a turn. Have an assistant press brake pedal slowly through full travel, close bleeder fitting, and then return brake pedal slowly to full released position. Repeat operation until no air bubbles are visible at submerged end of hose.
  3. Tighten bleed fitting when fluid is completely free of air bubbles, and remove drain hose. Refill master cylinder reservoir and repeat procedure on left rear, right front and left front wheels. Refill reservoir after each wheel is bled.
  4. Install New Generation Star (NGS) tester with Cable (007-00531) to Data Link Connector (DLC) located behind left side of instrument panel, and follow NGS tester instructions. Repeat bleeding procedure for all 4 wheels.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.