Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Section 464 (Engine Cooling System)
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- General Procedures
- Removal And Installation
- Block Heater
- Thermostat - Water, 3.0L
- Thermostat - Water, 4.0L
- Thermostat Housing - 2.3L
- Bypass Tube - 3.0L
- Water Pump - 2.3L
- Water Pump - 3.0L
- Water Pump - 4.0L
- Radiator - 2.3L
- Radiator - 3.0L and 4.0L
- Fan - Blade and Clutch, 2.3L
- Fan - Blade
- Cooling Fan Motor and Shroud - 2.3L
- Cooling Fan Shroud - 3.0L and 4.0L Printable
- Hose - 2.3L Exhaust Gas Recirculation (EGR) Valve Heater Hose
- Water Bypass Hose - 2.3L
- Coolant Outlet Pipe - 2.3L, Front
- Coolant Outlet Pipe - 2.3L, Rear
- Degas Bottle - 2.3L
- Coolant Expansion Tank - 3.0L, 4.0L
- Engine Coolant Temperature Sender Unit - 2.3L
- Engine Coolant Temperature Sender Unit - 3.0L
- Engine Coolant Temperature Sender Unit - 4.0L
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
