Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Description | N.m | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Power steering mounting bracket | 9 | - | 80 | ||
| Fan clutch-to-water pump pulley | 55 | 41 | - | ||
| Radiator coolant recovery reservoir-to-body | 7 | - | 5 | ||
| Draincock stem | 2 | - | 18 | ||
| Engine coolant temperature sender unit - 3.0L | 17 | 13 | - | ||
| Engine coolant temperature sender unit - 2.3L | 21 | 15 | - | ||
| Water pump pulley | 25 | 18 | - | ||
| Water pump pulley bolts - 2.3L | 25 | 18 | - | ||
| A/C compressor mounting bracket - 3.0L (Rear) | 48 | 35 | - | ||
| A/C compressor mounting bracket - 3.0L (Front) | 51 | 38 | - | ||
| Water hose connection | 10 | - | 89 | ||
| Water outlet connection - 3.0L | 25 | 18 | - | ||
| Coolant outlet pipe - Front | 25 | 18 | - | ||
| Coolant outlet pipe - Rear | 10 | - | 89 | ||
| EGR valve heater hose | 20 | 17 | - | ||
| Oil level indicator tube | 10 | - | 89 | ||
| Thermostat housing bolts | 10 | - | 89 | ||
| Transmission oil line fitting to radiator | 20 | 15 | - | ||
| Air deflector to frame | 15 | 11 | - | ||
| Block heater | 2 | - | 18 | ||
| Radiator to radiator support | 7 | - | 62 | ||
| Fan to clutch bolts | 7 | - | 62 | ||
| Generator wiring harness bracket nut | 10 | - | 89 | ||
| Fan clutch to idler pulley - 2.3L | 55 | 41 | - | ||
| Water pump inlet tube attaching screws | 10 | - | 89 | ||
| Speed control actuator bolt | 11 | 8 | - | ||
| Water pump to cylinder block - 4.0L | (1) | - | - | ||
| Water pump to cylinder block - 3.0L | 10 | - | 89 | ||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
