2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Heater Core Backflushing

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL SPECIFICATIONS

Item Specification
Motorcraft Cooling System Flush VC-1 or equivalent ESR-M14P7-A
    WARNING: Do not open the cooling system while it is hot or while the engine is running.
  1. Partially drain the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING - 2.3L  or COOLING SYSTEM DRAINING, FILLING AND BLEEDING - 3.0L AND 4.0L .
  2. NOTE: Refer to the cooling system flusher manufacturer's operating instructions for particular vehicle hook-up.
  3. Use an appropriate cooling system flusher to back flush the heater core. Use premium cooling system flush.
  4. Fill the cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING - 2.3L  or COOLING SYSTEM DRAINING, FILLING AND BLEEDING - 3.0L AND 4.0L .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.