Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
General Specifications
WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Cooling System Capacities | |
| 2.3L manual transmission | 10.6L (11.2 qts) |
| 2.3L automatic transmission 3.0L manual transmission |
10.3L (10.9 qts) 14.4L (15.2 quarts) |
| 3.0L automatic transmission | 14.1L (14.8 quarts) |
| 4.0L manual transmission 4.0L automatic transmission |
12.8L (13.5 quarts) 12.5L (13.2 quarts) |
| Coolant Type | |
| Motorcraft Premium Gold Engine Coolant VC-7-A (in Oregon VC-7-B, in Canada VC-7-C) | WSS-M97B51-A1 |
| Other Chemicals | |
| Motorcraft Cooling System Flush VC-1 | ESR-M14P7-A |
| Pipe Sealant with Teflon® D8AZ-19554-A | WSK-M2G350-A2 and ESR-M18P7-A |
| Premium Long-Life Grease XG-1-C or XG-1-K | ESA-M1C75-B |
| Cooling System Stop Leak Pellets VC-6 | WSS-M99B37-B6 |
| Silicone Rubber (Clear) D6AZ-19562-AA | ESB-M4G92-A |
| Cooling system pressure test specifications | 138 kPa (20 psi) |
| Radiator cap pressure test specifications | 89-124 kPa (13-18 psi) |
| Thermostat Opening Temperature | |
| Starts to open | 90°C (194°F) |
| Fully open | 97-106°C (206.6-222.8°F) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
