Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
Module Communications Network
- Description & Operation
- Component Locations
- Repairing Bus Wiring
- Self-Diagnostic System
- System Tests
- Notes
- Test A: No Module/Network Communication With NGS Tester
- Test B: Anti-Lock Brake System (Abs) Module Does Not Respond To NGS Tester
- Test C: Restraint Control Module (RCM) Does Not Respond To NGS Tester
- Test D: Restraint Control Module (RCM) & Abs Module Do Not Respond To NGS Tester (Result Code 70=00000001)
- Test E: Powertrain Control Module (Pcm) Does Not Respond To NGS Tester
- Test F: Central Timer Module (CTM) Does Not Respond To NGS Tester
- Test G: No Module/Network Communication With NGS Tester (Result Code 00000003)
- Diagnostic Trouble Code (DTC) Definitions
- Parameter Identification (PID) Definitions
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
