Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE
System Tests: Notes
NOTE:
Always check module power and ground circuits prior to replacing a control module. See appropriate wiring diagram in DATA LINK CONNECTORS, GROUND DISTRIBUTION or POWER DISTRIBUTION article in WIRING DIAGRAMS.
SYMPTOM CHART
| Condition | Perform Test | ||
|---|---|---|---|
| No Module/Network Communication With NGS Tester | A | ||
| Anti-Lock Brake System (ABS) Module Does Not Respond To NGS Tester | B | ||
| Restraint Control Module (RCM) Does Not Respond To NGS Tester | C | ||
| Restraint Control Module (RCM) & ABS Module Do Not Respond To NGS Tester (Result Code 70=00000001) | D | ||
| Passive Anti-Theft System (PATS) Module Does Not Respond To NGS Tester | (1)E | ||
| Powertrain Control Module (PCM) Does Not Respond To NGS Tester | E | ||
| Central Timer Module (CTM) Does Not Respond To NGS Tester | F | ||
| No Module/Network Communication With NGS Tester (Result Code 00000003) | G | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
