1999 Ford Contour SVTFACTORY OEM SERVICE PROCEDURE

Component Locations

COMPONENT LOCATIONS

Component Location
Restraint Control Module (RCM) Under Center Console
Anti-Lock Brake System Module Left Rear Corner Of Engine Compartment
Central Timer Module Behind Driver's Side Of Instrument Panel, On Central Junction Box
Data Link Connector Below Driver's Side Of Instrument Panel, To Right Of Steering Column
Powertrain Control Module Right Side Of Engine Compartment, On Firewall
Passive Anti-Theft System Module (1)
In-Line Harness Connector C62 Behind Left Side Of Dash
In-Line Harness Connector C3001 Left Side Of Engine Compartment, On Strut Tower
(1) Passive Anti-Theft System (PATS) module is built into Powertrain Control Module (PCM).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.