Steering Wheel: Installation

1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2SECTION Installation
  1. Ensure front wheels are in straight-ahead position. Route clockspring wiring harness through steering wheel opening at 3 o'clock position. Position steering wheel on steering shaft and align marks made during removal procedure.
  2. Ensure air bag clockspring wire is not pinched when positioning steering wheel. Install new steering wheel retaining bolt, and tighten to specification. See TORQUE SPECIFICATIONSΒ  . Connect horn/speed control wiring harness (if equipped) to steering wheel and snap connector assembly into steering wheel clip.
  3. Install air bag module. Reconnect positive, then negative battery cable. Activate air bag system. Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECKΒ  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.