Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSFORD1996PICKUP F250, 2D PICKUP, 4.9 Y, STANDARD, M5OD-R2REPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSSUPPLEMENTAL INFLATABLE RESTRAINT SYSTEMSYSTEM OPERATION CHECK
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2
System Operation Check
1996 Ford Pickup F250, 2D Pickup, 4.9 Y, Standard, M5OD-R2SECTION System Operation Check
- When checking SRS operation, and upon completion of each diagnostic test, check for faults in SRS. To check system, turn ignition switch to RUN position. If AIR BAG warning light illuminates for 4-8 seconds and then goes out, SRS is functioning properly and no fault codes exist.
- If a fault code is detected in SRS during initial system check, AIR BAG warning light will either fail to light, stay on continuously, or flash a code sequence. If AIR BAG warning light flashes, indicating a fault in system, count number of flashes after fault code has cycled twice. Number of flashes represents a code number used to diagnose SRS. See DIAGNOSIS & TESTING .
- If a system fault exists and AIR BAG warning light fails to light, an audible tone will be heard, indicating AIR BAG warning light is out and service is required. See TONE GENERATOR under DESCRIPTION & OPERATION.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.