Cylinder Head

2023 Dodge and Ram Durango R/T Plus, AWDSECTION Cylinder Head
WARNING: This page is about a different variant/trim than selected.
CYLINDER HEAD

DESCRIPTION N. m Ft. Lbs. In. Lbs. COMMENT
Cylinder Head Bolts Specific torque and fastener pattern required. Refer to CYLINDER HEAD, INSTALLATION  .  
Cylinder Head Cover Bolts 11 - 97  
Exhaust Manifold Bolts 25 19 - Do not reuse these fasteners. If removed, a new fastener must be installed and tighten to specifications.
Ignition Coil Bolts 7 - 62  
Supercharger to Cyl. Head Bolts Specific torque and fastener pattern required. Refer to SUPERCHARGER, INSTALLATION .  
Lifter Guide Holder Bolts 12 9 -  
Rocker Arm Bolts Specific torque and fastener pattern required; follow installation sequence. Refer to ROCKER ARM, VALVE, INSTALLATION  .  
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.