SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (6.2L ENGINE (SERVICE INFORMATION))VALVE TIMINGTENSIONER, ENGINE TIMINGREMOVAL
2023 Dodge and Ram Durango GT, RWD

TENSIONER, Engine Timing: Removal

2023 Dodge and Ram Durango GT, RWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the timing cover. Refer to COVER(S), ENGINE TIMING, REMOVAL  .
  3. Remove the ignition coils. Refer to COIL, IGNITION, REMOVAL .
  4. Remove one spark plug from each cylinder.
    GC0158237Courtesy of CHRYSLER GROUP, LLC
  5. Install the crankshaft bolt and using a suitable socket and breaker bar, rotate the crankshaft to align the timing marks (1, 2).
  6. Assemble and mount the dial indicator to cylinder No. 1 to find Top Dead Center (TDC) on the compression stroke.
  7. Ensure that the camshaft gear (2) is aligned with the camshaft timing chain marks (1) in the twelve O'clock position and the engine is at TDC on the compression stroke.
    GC0184430Courtesy of CHRYSLER GROUP, LLC
  8. Secure the timing chain to the guide using a zip tie.
  9. Mark the crankshaft to oil pump housing at the twelve O'clock position (1).
    GC0209476Courtesy of CHRYSLER GROUP, LLC
  10. Retract the chain tensioner arm (1) until the hole in the arm lines up with the hole in the bracket.
    GC0158247Courtesy of CHRYSLER GROUP, LLC
  11. Install the Tensioner Pin (special tool #8514A, Pins, Tensioner) (2) into the chain tensioner holes.
  12. Remove the bolts (1) and the timing chain tensioner.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.