SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2023DURANGO GT, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (6.2L ENGINE (SERVICE INFORMATION))VALVE TIMINGCOVER(S), ENGINE TIMINGREMOVAL
2023 Dodge and Ram Durango GT, RWD

Cover(S), Engine Timing: Removal

2023 Dodge and Ram Durango GT, RWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
  1. Remove the supercharger. Refer to SUPERCHARGER, REMOVAL .
  2. Remove the supercharger belt tensioner. Refer to TENSIONER, DRIVE BELT, REMOVAL .
  3. Remove the water pump. Refer to PUMP, WATER, REMOVAL .
    GC0170371Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the camshaft position sensor wire harness connector (1).
  5. Remove A/C compressor from the engine timing chain cover and position aside. Refer to COMPRESSOR, A/C, REMOVAL .
  6. Remove the upper idler pulley or power steering pump bolts, depending on how equipped, and position aside.
  7. Remove the generator from the engine timing chain cover and position aside. Refer to GENERATOR, REMOVAL .
  8. Remove the vibration damper. Refer to DAMPER, VIBRATION, REMOVAL  .
    GC0184475Courtesy of CHRYSLER GROUP, LLC
  9. Remove the five front oil pan to timing cover bolts (1).
    GC0184502Courtesy of CHRYSLER GROUP, LLC
  10. Remove the right side coolant tube retaining bolt from the rear of the timing cover (1).
    GC0170372Courtesy of CHRYSLER GROUP, LLC
  11. Remove the engine timing cover retaining bolts (2) and remove the engine timing cover (1).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.