Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSDODGE AND RAM2013DART GTREPAIR AND DIAGNOSISSTEERINGELECTRONIC STEERINGELECTRONIC POWER STEERING (EPS) MODULE - ELECTRICAL DIAGNOSTICS
2013 Dodge and Ram Dart GT
Electronic Power Steering (EPS) Module - Electrical Diagnostics
2013 Dodge and Ram Dart GTSECTION Electronic Power Steering (EPS) Module - Electrical Diagnostics
- Diagnostic Code Index
- DTC Troubleshooting
- C0051-04 Steering Wheel Position Sensor - System Internal Failures
- C0051-2F Steering Wheel Position Sensor - Signal Erratic
- C0051-31 Steering Wheel Position Sensor - No Signal
- C0051-54 Steering Wheel Position Sensor - Missing Calibration
- C1592-01 Electronic Power Steering Motor Circuit - General Electrical Failure
- C1592-16 Electronic Power Steering Motor Circuit - Circuit Voltage Below Threshold
- C1592-29 Electric Power Steering Motor Circuit - Signal Invalid
- C1592-4B Electronic Power Steering Motor Circuit - Over Temperature
- C1592-74 Electronic Power Steering Motor Circuit - Actuator Slipping
- C1592-98 Electronic Power Steering Motor Circuit - Component Or System Over Temperature
- C15C1-00 EPS Mechanical Performance
- C15CA-00 Brake System Module - Event Information
- C2100-16 Battery Voltage Low - Circuit Voltage Below Threshold
- C2101-17 Battery Voltage High - Circuit Voltage Above Threshold
- C2129-13 Battery Voltage - Circuit Open
- C2202-00 Original VIN Mismatch/Missing
- C2217-00 Electric Power Steering Module Internal
- C221C-00 Ecu Flash Required
- C221F-00 Ecu Not Initialized
- U0001-87-Can-C Bus Missing Message
- U0002-00 Can C Bus Off Performance
- U0100-00-Lost Communication With ECM/Pcm
- U0121-00-Lost Communication With Anti-Lock Brake System (Abs) Control Module
- U0140-00-Lost Communication With Body Control Module (BCM)
- U0401-86-Implausible Data Received From ECM/Pcm - Signal Invalid
- U0415-00 Implausible Data Received From Abs
- U0415-86 Implausible Data Received From Abs - Signal Invalid
- U0422-00-IMPAUSIBLE Data Received From Body Control Module
- Standard Procedure
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.