Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER1993LEBARON LANDAUREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM - BENDIX-6DIAGNOSIS & TESTINGDRB-II TEST FUNCTIONSENTERING DRB-II MAIN MENU
1993 Chrysler LeBaron Landau
Entering DRB-II Main Menu
1993 Chrysler LeBaron LandauSECTION Entering DRB-II Main Menu
- Ensure ignition is off. Attach DRB-II to Chrysler Collision Detection (CCD) BUS data link connector. Data link connector is located behind fuse access cover on lower section of dash panel, left of steering column. See Figure and Figure . Turn ignition switch to RUN position.
- All DRB-II character positions will glow and copyright information will appear on screen for a few seconds. DRB-II main menu will appear after a few seconds. If DRB-II screen is blank, proceed to TEST 2A under SELF-DIAGNOSTICS. If DRB-II displays NO RESPONSE message, go to TEST 3A .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.