Removal Procedure

2019 Chevrolet Cruze LS, 4D HatchbackSECTION Removal Procedure
  1. GM4031950Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Water Deflector (1) - Remove - Rear Side Door Water Deflector Replacement

  2. GM3650440Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Locking Rod Knob (1) - Remove - Rear Side Door Locking Rod Knob ReplacementΒ 

  3. GM5043967Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Latch Electrical Connector (1) - Disconnect @ Rear Side Door Latch (2)

  4. GM3657276Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Window Channel Rear Retainer (2) - Remove Rear Side Door Window Channel Rear Retainer Replacement

  5. GM4422064Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Outside Handle (4) - Remove - Rear Side Door Outside Handle Replacement (without Keyless Entry)Β Rear Side Door Outside Handle Replacement (with Keyless Entry)Β 

  6. GM5043974Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Outside Handle Bracket Fastener (1) - Remove

  7. GM5043980Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Unclip @ Rear Side Door Outside Handle Bracket (2)

  8. GM5043982Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Latch Bolt (1) - Remove [2x]

  9. Rear Side Door Latch Bolt (2) - Remove
  10. GM5043983Courtesy of GENERAL MOTORS COMPANY

    Remove the rear side door latch and rear side door outside handle bracket (1) from rear side door.

  11. GM5043986Courtesy of GENERAL MOTORS COMPANY

    Rear Side Door Outside Handle Cable (1) @ Rear Side Door Outside Handle Bracket (2) - Remove - Rear Side Door Outside Handle Cable ReplacementΒ 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.