Rear Side Door Outside Handle Replacement (with Keyless Entry)

2019 Chevrolet Cruze LS, 4D HatchbackSECTION Rear Side Door Outside Handle Replacement (with Keyless Entry)
GM4422063Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Rear Side Door Trim Replacement
1 Bolt Access Plug
Procedure 
Use a flat bladed plastic tool to remove.
2 Rear Side Door Outside Handle Bolt
CAUTION:

Refer to Fastener Caution .

Procedure

  1. Loosen the rear side door outside handle bolt until the rear side door outside handle cap could be removed.
  2. The handle must be pulled rearward while the handle bolt is loosened.

Tighten 
4.7 N.m (42 lb in)
3 Rear Side Door Lock Cylinder Opening Cover
4 Rear Side Door Outside Handle

Procedure

  1. Pull the outside handle rearward to release it from the handle housing.
  2. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.