Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Steering Wheel And Steering Column
- Specifications
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- DTC B2850, B2855, B2870, or B2875: Telescope Switch Circuit Short to Battery, Tilt Switch Circuit Short to Battery
- Diagnostic Instructions
- DTC Descriptors
- Diagnostic Fault Information
- Circuit Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC B2860 or B2880: Telescope Position Sensor, Tilt Position Sensor
- DTC B2890: Tilt and Telescope Motor Circuit Calibration Not Learned
- Symptoms - Steering Wheel and Column
- Heated Steering Wheel Indicator Malfunction
- Heated Steering Wheel Malfunction
- Steering Column Tilt/Telescoping Malfunction
- Steering Column Tilt Function Inoperative
- Noise in Steering Column
- High Shift Effort
- Looseness in Steering Column
- DTC B2850, B2855, B2870, or B2875: Telescope Switch Circuit Short to Battery, Tilt Switch Circuit Short to Battery
- Repair Instructions
- Wire to Wire Repair - Steering
- Connector Reconnection - Steering
- Intermediate Steering Shaft Boot Replacement
- Intermediate Steering Shaft Replacement
- Steering Column Accident Damage Inspection
- Steering Column Upper Trim Cover Replacement
- Steering Column Lower Trim Cover Replacement (N37)
- Steering Column Lower Trim Cover Replacement (N38)
- Telescoping Steering Column Calibration
- Turn Signal Switch Bracket Replacement
- Turn Signal Multifunction Switch Replacement
- Steering Wheel Heat Control Module Replacement (Chevrolet)
- Steering Wheel Heat Control Module Replacement (Buick, GMC)
- Steering Wheel Replacement
- Steering Column Tilt Wheel and Telescope Switch Replacement
- Steering Column Tilt Wheel Position Sensor Replacement
- Steering Column Replacement (N37)
- Steering Column Replacement (N38)
- Steering Angle Sensor Replacement
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
