2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Turn Signal Multifunction Switch Replacement

Fig 1: Identifying Turn Signal Multifunction Switch
GM1857103Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Remove the steering column upper trim cover. Refer to Steering Column Upper Trim Cover ReplacementΒ .
  2. Remove the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement (N37)Β Steering Column Lower Trim Cover Replacement (N38)Β .
1 Turn Signal Multifunction Switch

Procedure

  1. Disconnect any electrical connectors as needed.
  2. Release the plastic retaining tabs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.