Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE
Fastener Specifications
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Intermediate Steering Shaft Lower Bolt | 25 N.m (18 lb ft) |
| Intermediate Steering Shaft Upper Bolt | 22 N.m (16 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal.Β |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Steering Column Bolt | 27 N.m (20 lb ft) |
| Steering Column Lower Support Brace Bolt | 10 N.m (89 lb in) |
| Steering Column Nut | 27 N.m (20 lb ft) |
| Steering Column Tilt Wheel Position Sensor Bolt | 0.5 N.m (4 lb in) |
| Steering Wheel Bolt | 45 N.m (33 lb ft) |
| Steering Wheel Shroud Bolt | 2.5 N.m (22 lb in) |
| Turn Signal Switch Bracket Bolt | 9 N.m (80 lb in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
