2017 Chevrolet Traverse LS BaseFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Steering Wheel Heat Control Module
    GM4056408Courtesy of GENERAL MOTORS COMPANY
  1. Gently install the steering wheel heat control module (1) in the steering wheel shroud.
  2. Connect the electrical connectors to the steering wheel heat control module.
  3. Fig 2: Steering Wheel Shroud Bolts
    GM4056406Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.