SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008HHR LT, 2.4 P, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 175 (STARTING SYSTEM)SYMPTOM TROUBLESHOOTING INDEX
2008 Chevrolet HHR LT, 2.4 P, Automatic

Symptom Troubleshooting Index

2008 Chevrolet HHR LT, 2.4 P, AutomaticSECTION Symptom Troubleshooting Index
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
SYMPTOM TROUBLESHOOTING CHART

Symptom Diagnostic procedure Also check for
Engine does not start (does not crank)
  1. Check for PGM-FI DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  2. Check for loose battery terminals or connections.
  3. Test the 12 volt battery for a low state of charge (see 12 VOLT BATTERY TEST ).
  4. Check the starter (see STARTER SYSTEM CIRCUIT TROUBLESHOOTING  ).
  5. Check the starter cut relay (see POWER RELAY TEST ).
  6. Check the transmission range switch (see TRANSMISSION RANGE SWITCH TEST ).
  7. Check the ignition switch or related circuits (see PARK PIN SWITCH TEST ).
 Poor Ground At G101
Engine cranks, but does not start
  1. Check for PGM-FI DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  2. Check for IMMOBI status and function (see SYMPTOM TROUBLESHOOTING INDEX ).
  3. Check the fuel pressure (see FUEL PRESSURE TEST ).
  4. Check for a plugged or damaged fuel line (see FUEL LINE INSPECTION ).
  5. Check for a plugged fuel filter (see FUEL PRESSURE REGULATOR REPLACEMENT ).
  6. Check the throttle body (see THROTTLE BODY TEST ).
  7. Check for low engine compression (see ENGINE COMPRESSION INSPECTION ).
  8. Check for a damaged or broken cam chain.
  9. Do the powertrain control module (PCM) reset function with Honda Diagnostic System (HDS) to cancel the ALL INJECTORS STOP function.
  • Weak or fouled spark plugs
  • Poor quality fuel
Engine is hard to start
  1. Check for PGM-FI DTCs (see GENERAL TROUBLESHOOTING INFORMATION ).
  2. Check the fuel pressure (see FUEL PRESSURE TEST ).
  3. Check for a plugged or damaged fuel line (see FUEL LINE INSPECTION ).
  4. Check for a plugged fuel filter (see FUEL PRESSURE REGULATOR REPLACEMENT ).
  • Weak or fouled spark plugs
  • Poor quality fuel
Engine cranks slowly
  1. Check for loose battery terminals or connections.
  2. Test the 12 volt battery for a low state of charge (see 12 VOLT BATTERY TEST ).
  3. Check the starter for binding (see STARTER SYSTEM CIRCUIT TROUBLESHOOTING  ).
  4. Check for excessive drag in the engine.
  5. Check for excessive drag in the transmission.
  
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.