Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 587 (WIPER SYSTEM & WASHER SYSTEM)
2006 Chevrolet Cobalt SS, 4D Sedan, Standard
Section 587 (Wiper System & Washer System)
2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Section 587 (Wiper System & Washer System)
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Wiper/Washer Systems
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- DTC B3715, B3716, B3717, B3718, or B3719
- Symptoms - Wiper/Washer Systems
- Washers Always On
- Washers Inoperative
- Wipers Always On
- Wipers Inoperative - All Modes
- Wipers Inoperative - One or More Modes (Front Wiper)
- Wiper Arm Tip Pressure Check
- Wiper Blade Element Check
- Repair Instructions
- Wipers/Washer Switch Replacement
- Washer Nozzle Replacement - Front
- Hose Replacement - Windshield Washer
- Washer Solvent Container Replacement
- Washer Pump Replacement
- Air Inlet Grille Panel Replacement
- Wiper Arm Replacement
- Wiper Arm Blade Replacement
- Wiper Blade Element Replacement
- Wiper Motor Replacement
- Wiper Drive System Module Replacement
- Windshield Glass Cleaning
- Blade Element Cleaning
- Wiper Chatter Repair
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.