SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006COBALT SS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 587 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWASHER SOLVENT CONTAINER REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Cobalt SS, 4D Sedan, Standard

Removal Procedure

2006 Chevrolet Cobalt SS, 4D Sedan, StandardSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  1. Remove the front fender liner. Refer to Front Fender Liner Replacement .
  2. Disconnect the washer pump hose from the pump.
  3. Drain the washer solvent from the washer solvent container and store in a suitable clean container.
  4. Disconnect the washer pump and level sensor switch electrical connectors.
    5. Fig 2: Locating Washer Solvent Container
    GM869670Courtesy of GENERAL MOTORS CORP.
  5. Remove the washer solvent container screws.
  6. Remove the washer solvent container from the right frame rail.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.