Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSISRESTRAINTSRESTRAINTS CONTROL SYSTEMSSEAT BELT SYSTEM
2002 Chevrolet Venture Plus
Seat Belt System
2002 Chevrolet Venture PlusSECTION Seat Belt System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Repair and Inspections Required After a Collision
- Seat Belt Buckle Replacement - Left Front
- Seat Belt Buckle Replacement - Right Front
- Seat Belt Buckle Replacement - Rear (Captains Chair)
- Seat Belt Buckle Replacement - Rear (Bucket Seat)
- Seat Belt Replacement - Center Rear (60/40 Split Bench)
- Seat Belt Replacement - Center Rear (50/50 Split Bench)
- Seat Belt Replacement - Center Rear (Full Bench)
- Shoulder Belt Guide Adjuster Replacement - Front
- Seat Belt Retainer Replacement - Rear
- Seat Belt Retractor Replacement - Left Front
- Seat Belt Retractor Replacement - Right Front
- Seat Belt Retractor Replacement - Rear
- Seat Belt Retractor Replacement - No. 3 Rear
- Child Restraint Belt Tether Location (Center-Third Row Bucket)
- Child Restraint Belt Tether Location (Outboard-Third Row Seat)
- Child Restraint Belt Tether Location (Outboard-No Third Row Seat)
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.