Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2002 Chevrolet Venture PlusSECTION Installation Procedure
- Install the tether strap to the vehicle.
- Route the tether strap underneath the head restraint if equipped.
- Route the tether strap between the second row bucket seat cushion and the seat back.
- Install the anchor plate to the buckle seat frame.NOTE: Refer to FASTENER NOTICE .
- Install the anchor plate bolt and the nut.
Tighten
Tighten the child seat tether strap anchor plate bolt and the nut to 10 N.m (89 in lb).
- Install the tether strap spring clip to the anchor plate. Verify that the spring clip end closes once the spring clip is attached to the anchor plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.