Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Electrical System - Repair Instructions
2001 BMW M5SECTION Engine Electrical System - Repair Instructions
- Troubleshooting
- 12 00 Contents of Engine Electrical System General
- 12 00 ... Instructions for disconnecting and connecting battery
- 12 00 ... Information on working on ignition system
- 12 00 ... Instructions for removing and installing electronic control units
- 12 00 ... Instructions for welding work (overload protection of control units)
- 12 00 ... Instructions for connecting and disconnecting test units
- 12 00 ... Instructions on component testing
- 12 00 ... Instructions on external starting aid
- 12 13 Notes on checking ignition system
- Ignition Wires, Spark Plugs
- Ignition Coil
- 12 13 Notes on checking ignition system
- 12 13 ... Checking secondary signal for stationary ignition distribution
- 12 13 ... Normal oscillogram (M, S, W engines only)
- 12 13 ... Oscillograms of ignition coils from different manufacturers
- 12 13 ... Fault in fuel injection system
- 12 13 ... Spark-Plug Faults
- 12 13 ... Ignition Coil Faults
- 12 13 ... Further Fault Patterns With Evaluation
- 12 13 ... Additional Fault Notes For Troubleshooting
- 12 13 009 Checking ignition coils (M60, M62, S62)
- 12 13 009 Checking ignition coils (secondary coil)
- 12 13 511 Replacing ignition coil (S62)
- Electronic Switching Or Control Unit
- 12 14 520 Replacing pulse generator (M62)
- 12 14 523 Replacing pulse generator for inlet camshaft (S62)
- 12 14 524 Replacing pulse generator for exhaust camshaft (S62)
- 12 14 550 Replacing control unit (DME) (S62)
- 12 14 610 Replacing right knock sensors (cylinder bank 1-4) (S62)
- 12 14 611 Replacing left knock sensors (cylinder bank 5-8) (S62)
- 12 14 700 Coding control module (DME/DDE)
- 12 14 705 Programming control unit (DME/DDE)
- 12 63 520 Replacing main relay (S62, M54)
- 12 72 010 Removing and installing/replacing throttle actuator (S62)
- 13 63 555 Replacing throttle potentiometer (S62)
- 61 35 ... Note on replacing codable/programmable control units
- Alternator With Drive
- Regulator
- Starter With Mounting
- Starter Lead
- Engine Wiring Loom
- Oil Pressure/Oil temperature Switch
- Coolant Temperature
- Switches and relays
- Sensor For Control Unit
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.