Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check The Diagnostic Trouble Codes (DTCS) For Text Id 162
Note that this text message is displayed together with:
- Incorrect key
- New key.
- Replace the central electronic module (CEM).
Click on the VCT2000 symbol.
Check if any of the following diagnostic trouble codes have been generated in the vehicle.
Remedy as necessary.
- CEM-6C41.
Refer to FAULT-TRACING INFORMATION
- CEM-6C42.
Refer to DOWNLOADING NEW SOFTWARE
- CEM-6C43.
Refer to DOWNLOADING NEW SOFTWARE
- CEM-DD11 (A).
Refer to CHECKING THE CONNECTOR
Other diagnostic trouble codes that may be stored in the control modules in the vehicle are not relevant for this text message.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.