Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSYMPTOM RELATED DIAGNOSTIC PROCEDURESCHECKING THE GEAR POSITION INDICATOR
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Checking the Gear Position Indicator
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Checking the Gear Position Indicator
Checking the gear position indicator
Checking the gear position indicator
- Ignition on.
Depress the brake pedal. Move the gear shift selector to the different positions. Check that the gear position indicator LED in the gear selector assembly panel displays the selected gear position.
Replace the printed circuit board in the gear selector assembly if the gear position indicator LED does not display the selected gear.
Other information:
- To replace the printed circuit board, see Printed circuit board gear selector assembly / top panel, replacing Printed Circuit Board Gear Selector Assembly/Top Panel, Replacing.
Was a fault detected?
Yes - Verification
No - No Fault Found
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition on.
Depress the brake pedal. Move the gear shift selector to the different positions. Check that the gear position indicator LED in the gear selector assembly panel displays the selected gear position.
Do the gear indicator LEDs follow the gear position?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - Fault Found
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking the gear position indicator
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.