Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESHIFT INTERLOCKSHIFT INTERLOCK CABLESERVICE AND REPAIRPROCEDURES
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Procedures
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Procedures
Key interlock cable, initial setting and adjustment
Key interlock cable, initial setting and adjustment
Turn the ignition key to position 0.
Move the gear shift lever to position P.
Position a 5 mm drill bit in the housing above the yellow locking sleeve. This is to get the lever into the secured position.
Install a new locking sleeve in position (1) as illustrated.
Install the cable on the housing and on the threaded end in the groove on the yellow locking sleeve.
Press the locking sleeve in to position (2) as illustrated so that it locks the cable.
Check
Check that the key cannot be removed when the gear selector is in any other position than P.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.