Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTCOMMUNICATIONS CONTROL MODULETESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDESCRIPTION OF PARAMETERS
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Description of Parameters
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Description of Parameters
Description of parameters
Signal strength
Indicates signal amplitude in the interval 0-255. To obtain corresponding dBµV-value, use the following conversion table.
Due to tolerances of the units, the values in the conversion table shall be regarded as approximate.
Note! Parameters that show status of the buttons are only available for vehicles equipped with steering wheel buttons as well as on model year 2005 and later.
The following buttons refer to the steering wheel buttons.
Buttons have two possible status modes:
Off = Control module does not consider selected button pressed in.
On = Control module considers selected button pressed in.
Buttons
Volume up
The value shows if the button for adjusting volume up is pressed in.
Volume down
The value shows if the button for adjusting volume down is pressed in.
Next up
The value shows if the button for selecting next sound track or radio station is pressed in.
Next down
The value shows if the button for selecting previous sound track or radio station is pressed in.
On-button, telephone (green telephone)
The value shows if the on-button for the telephone is pressed in.
Off-button, telephone (red telephone)
The value shows if the off-button for the telephone is pressed in.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.