Camshaft Diagnostics (CVVT)

Camshaft diagnostics (CVVT)
In addition to electrical checks of the camshaft reset valve, the engine control module (ECM) checks that the position of the camshaft is correct and that the control (deployment and return of the camshaft) is working satisfactorily. The control module uses the signals from the camshaft position sensor and engine speed (RPM) sensor (crankshaft position) for the diagnostics.

Checking the camshaft position
The control module checks that the 0 position of the camshaft (mechanical rest position) is correct. At idle speed camshaft control is not active. The control module checks the camshaft deviation from the 0 position, that is, how much the camshaft flanks deviate from the predetermined positions on the crankshaft.
The position of the camshaft is stored in the control module. If the position is incorrect the diagnostic trouble code (DTC) is stored in the engine control module (ECM). The camshaft position value can be read off using VIDA.

Checking the camshaft control
Active camshaft control checks that the camshaft assumes the position the control module intends the camshaft to move to, that is that the correct camshaft angle is obtained. This is done by measuring the time the system takes to deploy to the correct camshaft position (the transition time from the actual to the desired camshaft angle). A diagnostic trouble code (DTC) is stored in the engine control module (ECM) If the camshaft angle does not reach the desired value within a certain time frame.
The actual value and the desired value for the camshaft's angle can be read using VIDA.