Timing Components: Specifications

Tighten the center screw for the variable valve timing (VVT) unit. Tighten 120 Nm

The center plug. Tighten 35 Nm

Tighten the center screw on the timing belt tensioner 5 Nm

Tighten the three screws securing the timing gear pulley for the exhaust camshaft to the variable valve timing unit 10 Nm

Install the third screw at the timing gear pulley for the intake camshaft. Tighten the screws 20 Nm

Hold the eccentric secure and tighten the center screw. Tighten 20 Nm

The plug with a new blind cover plug. Tighten 40 Nm

The Vibration Damper
Tighten the center nut 180 Nm
Tighten the four screws 25 Nm
Angle tighten 30 degrees
Use the crankshaft center screw as a counterhold.

Remove the counterhold and install new screws.
Tighten the screws 25 Nm
Angle-tighten 30 degrees

The front timing belt cover. Tighten 12 Nm

The engine stabilizer brace.
Tighten the screws at the suspension turrets. Tighten 50 Nm
Tighten the engine bracket screw. Tighten 80 Nm

Center screw for the timing belt 25 Nm

Timing gear pulley
(camshafts without variable valve timing) 20 Nm

Timing gear pulley (camshafts with variable valve timing) 10 Nm

Timing cover, (front/rear) 12 Nm

Timing cover, (upper) 8 Nm

Spin the idler pulley and listen for noise.
If replacing with a new idler pulley, tighten 24 Nm