Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER HEAD ASSEMBLYSPECIFICATIONSTIGHTENING TORQUEINTAKE MANIFOLD COMPONENTS
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Intake Manifold Components
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Intake Manifold Components
Tighten the center screw on the belt tensioner 5 Nm
Tighten the screws on the exhaust camshaft timing gear pulley 10 Nm
Hold the eccentric secure and tighten the center screw. Tighten 25 Nm
The plug with a new sealing washer. Tighten 40 Nm
The pipe screw for the water heated crankcase ventilation at the rear of the cylinder head. Use new seal washers. Tighten 26 Nm
The pipe screw for the crankcase ventilation on the underside of the intake manifold. Use new seal washers. Tighten 26 Nm
The rest of the screws holding the intake manifold to the cylinder head.
Tighten 19 Nm
Manifold (cylinder head side) 25 Nm
Intake manifold 19 Nm
Spark plugs, Tighten 30 Nm
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.