Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSECM CODES (ENGINE CONTROL MODULE)ECM-986ADIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-986A
Condition
Diagnostic trouble code (DTC) ECM 986A is stored if the engine control module (ECM) registers an internal fault where the input signals from the throttle unit position sensor are interpreted by the normal engine control functions as having exceeded their minimum or maximum limits, while the internal monitoring function interprets the input signals from the electronic throttle unit position sensor differently.
Substitute value
The engine speed (RPM) and torque are limited to a calculated normal operating range.
Possible source
- Defective engine control module (ECM).
Fault symptom[s]
- Maximum engine speed (RPM) too low
- Cruise control does not function at all
- Uneven idle
- Malfunction indicator lamp (MIL) lit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.