Diagnostic Trouble Code (DTC) Information

2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition




Diagnostic trouble code (DTC) ECM-9540 is stored if the engine control module (ECM), when the ignition is on, registers that the pulse width modulation (PWM) signal for the accelerator pedal (AP) position sensor deviates from the basic frequency of 200 Hz by more than ±70 Hz.

Substitute value
None.

Possible source

Faulty signal:
- Contact resistance or oxidation in the terminals between the engine control module (ECM) and the accelerator pedal (AP) position sensor
- Open-circuit or short-circuit to ground or supply voltage in the signal cable
- Defective accelerator pedal (AP) position sensor.

Fault symptom[s]
- None.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.