Diagnostic Trouble Code (DTC) Information

2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Diagnostic Trouble Code (DTC) Information





Diagnostic trouble code (DTC) information

Condition




Diagnostic trouble code (DTC) ECM-4000 is stored if the signal from the canister purge (CP) valve is too high, too low or missing.

Substitute value
twin heated oxygen sensor (HO2S) control disabled.

Possible source

Signal too high:
- short-circuit to supply voltage in the signal cable
- defective canister purge (CP) valve

Signal too low:
- short-circuit to ground in the signal cable

Signal missing:
- open-circuit in the signal cable
- defective canister purge (CP) valve
- contact resistance in terminals
- open-circuit in power cable

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.