Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCCM CODES (CLIMATE CONTROL MODULE)CCM-0017DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
The control module stores diagnostic trouble code (DTC) CCM-0017 after it has detected the diagnostic trouble code (DTC) 5 times within a 10 second interval. After diagnostic trouble code (DTC) CCM-0017 has been stored 5 times, diagnostic trouble code (DTC) CCM-0018 is also stored.
If one or more damper motors is in motion when diagnostic trouble code (DTC) CCM-0017 is stored, a diagnostic trouble code (DTC) for the appropriate damper motor will also be stored (CCM-0011-CCM-0016).
Substitute value
- None.
Possible source
- Short-circuit to ground in the signal cable
- Short-circuit to supply voltage in the ground lead.
Fault symptom[s]
- Air flow problem
- The passenger compartment temperature does not correspond to the set value.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.