Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.5L TURBO VIN 59 B5254T2REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSCCM CODES (CLIMATE CONTROL MODULE)CCM-0004DIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.5L Turbo VIN 59 B5254T2SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
If the air conditioning (A/C) compressor has been in operation for its maximum run time, it is disengaged for 3 minutes. The run time is a function of the outside temperature. It then starts again. Diagnostic trouble code (DTC) CCM-0004 is stored if this happens 3 times. The counter is reset if the ignition key is turned to position 1. The A/C compressor can then run again.
Substitute value
- None.
Possible source
- The CAN-bus displays an incorrect configuration ID.
- Low coolant level.
- Low pressure in the air conditioning (A/C) system.
Fault symptom[s]
- The air conditioning (A/C) system does not operate.
- The air conditioning (A/C) compressor does not start, or runs sporadically.
- Sporadic cooling from the air conditioning (A/C) system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.