Driver Door Module (DDM)

Driver door module (DDM), replacing

Preparations

Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity which is required to order the correct software.

Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the cause of the fault.

Removing the driver door module (DDM)




Ignition off.

Remove:
- the door panel, see Replacing the front door side panel Front Door Side Panel.
- the nut and screw holding the control module in place
- the connectors.
Pull up the rear edge of the door module.
Pull the control module backwards and upwards.
Detach the control module from the mounting on the door panel.
Press up the control module.
Disconnect the catches. Lift the upper panel from the control module.

Note! Check that the control module's connectors are intact.

Installing the driver door module (DDM)
Install the upper panel.
Position the control module in the hole on the door panel.
Check that the lower mounting for the control module is correctly located in the support on the door panel.
Press the control module into place.

Install:
- the connectors
- the nut and screw
- the door panel, see Replacing the front door side panel Front Door Side Panel.

Ordering software
Order software for the driver door module (DDM) according to the table below.






Finishing
Initialise the window position in the communication input.