Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSTCM CODES (TRANSMISSION CONTROL MODULE)TCM-010FPERMANENT FAULTDIAGNOSTIC TROUBLE CODE (DTC) INFORMATION
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
Lock-up solenoid SL controls the transmission lock-up function. Solenoid SLU operates when it receives voltage from the transmission control module (TCM) and is activated under different driving conditions depending on road speed, throttle position and the driving mode selected. Diagnostic trouble code (DTC) TCM-010F is stored if the control module registers an open-circuit in the solenoid SL circuit when the solenoid should be activated. Solenoid SLU cannot then be activated.
Substitute value
- The transmission control module (TCM) "Emergency mode I" program has been initiated.
- The transmission control module (TCM) does not activate the lock-up solenoid.
Possible source
- Contact resistance in terminals.
- Open-circuit in the signal cable.
- Defective solenoid.
- Open-circuit in the power ground.
- Defective control module.
Fault symptom[s]
- General orange warning lamp lit.
- No lock-up function.
- Harsh gear shifting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.