Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSVOLVO2004V70 L5-2.4L VIN 64 B5244S6REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSSAS CODES (STEERING WHEEL ANGLE SENSOR MODULE)SAS-0005INTERMITTENT FAULTSIGNAL TOO HIGH. INTERMITTENT FAULT
2004 Volvo V70 L5-2.4L VIN 64 B5244S6
Signal Too High. Intermittent Fault
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Signal Too High. Intermittent Fault
Signal too high. Intermittent fault
Checking the wiring and connections
Check the wires between steering wheel angle sensor (SAS) control unit #4 (#A28) and steering wheel control unit (SWM) #3 (#A3) for a short circuit to voltage supply, as described in Checking wiring and terminals. Intermittent faults Checking Wiring and Terminals. Intermittent Faults.
Additional information:
- To connect the test box to the steering wheel angle sensor (SAS), see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification.
- To connect the test box to the steering wheel control unit (SWM), see Connecting the breakout box Connecting the Breakout Box, Steering Wheel Module (SWM).
- For information on signals to the steering wheel angle sensor (SAS) control unit, see Signal description, Control unit for the steering wheel angle sensor (SAS) Signal Specification.
- For information on signals to the steering wheel control unit (SWM), see Signal specification Signal Specification, Steering Wheel Module (SWM).
Continue - Trouble-shooting information
-------------------------------------------------
Trouble-shooting information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - Fault Found
------------------------
Attempt New Test - Checking the wiring and connections
FAULT FOUND - Fault Found
-------------------------------------------------
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.