Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information
Condition
If the engine is hot when the ignition is switched on, an adaptation of the reset valve (Continuous variable valve timing) takes place. The control engine control module (ECM) then checks that the continuous variable valve timing (CVVT) limit position is reached. If this limit position is not reached, the engine control module (ECM) registers this as a fault and stores diagnostic trouble code (DTC) ECM-640F.
Substitute value
- none.
Possible source
Incorrect signal:
- incorrect base setting of the timing belt.
Fault symptom[s]
- Malfunction indicator light (MIL), on
- uneven idle
- poor performance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.