3 - Intermittent Fault

2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION 3 - Intermittent Fault


Intermittent Fault
The control module has previously detected a fault in the leak diagnostic unit but the fault is not active at present.

Check the leak diagnostic unit connectors. Check for contact resistance and oxidation.

Check the hose and the filter for the air intake on the leak diagnostic unit.
Check for blockages.

Remedy as necessary.

Other Information:
- For resistance values, see Component specifications.
- To connect the breakout box, see Scan Tool Connecting.
- To access or replace the leak diagnostic unit, see Leak diagnostic unit, replacing.
- For information about signals, see Diagnostic Parameters and Pinout Values.
- Checking wiring and terminals.

Continue: Refer to Fault-Tracing Information - Intermittent Fault. Fault-Tracing Information - Intermittent Fault
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.