Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Trouble Code (DTC) Information
2004 Volvo V70 L5-2.4L VIN 64 B5244S6SECTION Diagnostic Trouble Code (DTC) Information
Diagnostic trouble code (DTC) information ECM-140A
Condition
The engine control module (ECM) measures the pressure in the intake manifold using a sensor.
The diagnostic trouble code (DTC) is stored if the engine control module (ECM) detects that the sensor value deviates too much from a calculated model.
The diagnostic trouble code (DTC) is diagnosed at a fixed engine speed above 1100 rpm and with the engine at operating temperature (>70 °C).
Substitute value
- Value from the mass air flow (MAF) sensor is used.
Possible source
- Contact resistance in the connector
- Defective hose connector
- Damaged manifold absolute pressure (MAP) sensor.
Fault symptom[s]
- Malfunction indicator lamp (MIL) lit
- Poor accelerator pedal (AP) response.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.